Dongfeng Duolika 12m3 Bulk Feed Transport Truck is composed of a chassis, loading feed tank, discharging auger system and electro-hydraulic operating system.
The tank body of the feed truck is welded and formed by high-quality steel plates, and the sub-silo can load and unload a variety of different feeds at the same time. It is mainly used in various feed factories, large-scale breeding plants and other granular feeds. It can also be used to transport certain non-corrosive granules. Raw materials, etc.
Dongfeng Dolica 2030 wide single-row body, Chaochai 120 horsepower engine, six-speed gearbox, direction assisted, ABS, 8.25R20 steel wire tires, 5.5 tons rear axle, air brake, tank size: 4650×2200×1920(mm ).
Effective volume is 12 cubic meters, can hold 6-8 tons, standard 3 warehouses, electric screw auger discharge, discharge pipe inclined 70 degrees, vertical discharge height 8.5 meters, vehicle size: 71002200X3400; when the vehicle is used up, it is 20 minute.
12m3 Bulk Feed Transport Truck are mainly used to transport finished bulk feed products or raw feed production from feed mills to livestock farms and poultry farms and feed processing users. At the same time, it can also be used to transport certain non-corrosive powdery and granular raw materials, such as pharmaceutical factory powder and Grain depot turnover.
The feed tank of the bulk feed truck is erected on the chassis of the truck, and the top of the tank has an inlet. A screw conveying unloading pipe (commonly known as the unloading screw) at the top can rotate and lift freely, and the elevation angle of the lift can reach 70 degree.
During transportation, the spiral tube at the top lies on the top of the tank; when unloading, it is lifted so that the discharge port at the end of the tube is connected with the feed door on the top of the storage tank of the livestock and poultry farm. The cab is equipped with a control device (operating The device can also be installed at the end of the tank. When unloading, the screw is driven by the power output shaft and the reducer under the vehicle to complete the unloading.
At present, several tonnage models such as 3T, 5T, 8T, 11T, 15T and 22T are mainly launched in China. The 12m3 Bulk Feed Transport Truck has the following characteristics:
- Transporting feed in bulk saves labor and costs less than transporting feed in bags. However, the livestock and poultry farms are required to have storage tanks for the feed.
- Bulk feed is sealed and transported in the tank to reduce loss, ensure quality and avoid pollution. Fully automatic loading and unloading, continuous operation, greatly improving production efficiency.
- Fully automatic hydraulic system, easy to operate and easy to use. The chassis is a truck chassis, and other components, gear pumps, hydraulic motors, etc. are also standardized, and imported hydraulic parts are made in China, which provides convenient conditions for maintenance.
- Separate silos can be installed in the tank, which can transport many different types of feed or puffing media at the same time. The body material of the Dongfeng Duolika bulk feed transporter is made of 4mm high-quality carbon steel plate. The whole car uses three augers (lifting auger, vertical auger, horizontal auger), driven by three 5.5KW motors, and used for the top lifting auger Hydraulic control lifting, can rotate 180 degrees left and right.
- It can be divided into 2-4 independent compartments according to the volume of the tank, and the unloading sequence and speed of each bin can be controlled separately. The maximum elevation angle of the top auger is 60 degrees, the standard length is 6.86 meters (optional lengthening), the maximum conveying height is 7-9 meters, the discharge speed is ≥510kg/min, the discharge residual rate is ≤0.1%, and the full load is 40 cubic meters of feed. It can be completed in about 35 minutes, which greatly saves time.
